The ESI data ingested by github.com/linuxcnc-ethercat/esi-data describes 1 revision(s) of this hardware. Here are the known revisions and their differences.
This also includes the send and receive PDOs defined for each revision, and a link to other known devices with identical PDOs.
| Revision | r16 |
|
| Name | EL2596-0010 1Ch. LED strobe control terminal 48V/3A |
|
| PID | 0x0a243052 |
|
| Revision Code | 0x0010000a |
|
| Equivalant Devices | EL2596 r18 |
|
| TX PDOs | 0x1a00: DOX Status |
|
0x6000:01 Status__Ready to activate BOOL |
||
0x6000:02 Status__Output active BOOL |
||
0x6000:04 Status__Switching operation counter BIT3 (3 bits) |
||
0x6000:07 Status__Warning BOOL |
||
0x6000:08 Status__Error BOOL |
||
0x6000:0c Status__Digital input BOOL |
||
0x6000:10 Status__TxPDO Toggle BOOL |
||
0x1a01: DOX Synchron info data |
||
0x6000:11 Info data 1 UINT (16 bits) |
||
0x6000:12 Info data 2 UINT (16 bits) |
||
| RX PDOs | 0x1600: DOX Control |
|
0x7000:01 Control__Enable BOOL |
||
0x7000:02 Control__Output BOOL |
||
0x7000:04 Control__Input trigger enable BOOL |
||
0x7000:05 Control__Output trigger enable BOOL |
||
0x7000:08 Control__Reset BOOL |
||
0x1601: DOX Current |
||
0x7000:11 Output current UINT (16 bits) |
||
0x1602: DOX Impulse length |
||
0x7000:12 Impulse length UDINT (32 bits) |
||
0x1603: DOX Trigger delay |
||
0x7000:13 Trigger delay UDINT (32 bits) |
||
0x1604: DOX PWM duty |
||
0x7000:14 PWM duty UINT (16 bits) |
||
0x1605: DOX Voltage |
||
0x7000:15 Output voltage UINT (16 bits) |
||
0x1606: DOX DC start time |
||
0x7000:16 DC Start time ULINT (64 bits) |
||
0x1607: DOX Trigger out delay |
||
0x7000:17 Trigger out delay UDINT (32 bits) |