The ESI data ingested by github.com/linuxcnc-ethercat/esi-data describes 1 revision(s) of this hardware. Here are the known revisions and their differences.
This also includes the send and receive PDOs defined for each revision, and a link to other known devices with identical PDOs.
| Revision | r18 |
|
| Name | EL5151-0021 1Ch. Inc. Encoder, 24V DC Output |
|
| PID | 0x141f3052 |
|
| Revision Code | 0x00120015 |
|
| Equivalant Devices | ||
| TX PDOs | 0x1a00: ENC Status |
|
0x6000:01 Status__Latch C valid BOOL |
||
0x6000:02 Status__Latch extern valid BOOL |
||
0x6000:03 Status__Set counter done BOOL |
||
0x6001:02 Status__Measurement done BOOL |
||
0x6000:09 Status__Status of input A BOOL |
||
0x6000:0a Status__Status of input B BOOL |
||
0x6000:0b Status__Status of input C BOOL |
||
0x6001:01 Status__Status of output BOOL |
||
0x6000:0d Status__Status of extern latch BOOL |
||
0x6000:0e Status__Compatible input cycle counter high BOOL |
||
0x6000:10 Status__TxPDO Toggle BOOL |
||
0x6000:11 Counter value UDINT (32 bits) |
||
0x6000:12 Latch value UDINT (32 bits) |
||
0x1a01: ENC Filtered latch |
||
0x6000:17 Latch value, rising edge UDINT (32 bits) |
||
0x6000:18 Latch value, falling edge UDINT (32 bits) |
||
| RX PDOs | 0x1600: ENC Control |
|
0x7000:01 Control__Enable latch C BOOL |
||
0x7000:02 Control__Enable latch extern on positive edge BOOL |
||
0x7000:03 Control__Set counter BOOL |
||
0x7000:04 Control__Enable latch extern on negative edge BOOL |
||
0x7000:05 Control__Set output BOOL |
||
0x7000:06 Control__Enable output functions BOOL |
||
0x7000:07 Control__Enable measurement BOOL |
||
0x7000:08 Control__Set counter on latch C BOOL |
||
0x7000:11 Set counter value UDINT (32 bits) |
||
0x7000:12 Switch on threshold value UDINT (32 bits) |
||
0x7000:13 Switch off threshold value UDINT (32 bits) |