The ESI data ingested by github.com/linuxcnc-ethercat/esi-data describes 1 revision(s) of this hardware. Here are the known revisions and their differences.
This also includes the send and receive PDOs defined for each revision, and a link to other known devices with identical PDOs.
| Revision | r21 |
|
| Name | EL7221 1Ch. MDP742 Servo motor output stage (50V, 8A RMS) |
|
| PID | 0x1c353052 |
|
| Revision Code | 0x00150000 |
|
| Equivalant Devices | EL7201 r21 |
|
| TX PDOs | 0x1a00: FB Position |
|
0x6000:11 Position UDINT (32 bits) |
||
0x1a01: DRV Statusword |
||
0x6010:01 Statusword UINT (16 bits) |
||
0x1a02: DRV Velocity actual value |
||
0x6010:07 Velocity actual value DINT (32 bits) |
||
0x1a03: DRV Torque actual value |
||
0x6010:08 Torque actual value INT (16 bits) |
||
0x1a04: DRV Info data 1 |
||
0x6010:12 Info data 1 UINT (16 bits) |
||
0x1a05: DRV Info data 2 |
||
0x6010:13 Info data 2 UINT (16 bits) |
||
0x1a06: DRV Following error actual value |
||
0x6010:06 Following error actual value DINT (32 bits) |
||
0x1a0c: FB Status |
||
0x6000:0e FB Status__TxPDO State BOOL |
||
0x6000:0f FB Status__Input Cycle Counter BIT2 (2 bits) |
||
| RX PDOs | 0x1600: DRV Controlword |
|
0x7010:01 Controlword UINT (16 bits) |
||
0x1601: DRV Target velocity |
||
0x7010:06 Target velocity DINT (32 bits) |
||
0x1602: DRV Target torque |
||
0x7010:09 Target torque INT (16 bits) |
||
0x1603: DRV Commutation angle |
||
0x7010:0e Commutation angle UINT (16 bits) |
||
0x1604: DRV Torque limitation |
||
0x7010:0b Torque limitation UINT (16 bits) |
||
0x1605: DRV Torque offset |
||
0x7010:0a Torque offset INT (16 bits) |
||
0x1606: DRV Target position |
||
0x7010:05 Target position DINT (32 bits) |